UMC-85™
85% Solids Moisture Cure Urethane
UMC-85 is a single component low odor ready-to-use moisture cure urethane, no measuring or portioning required. UMC-85 penetrates well into properly profiled surfaces to create a superior bond direct to concrete or can be used as a top coat over many other products. Low viscosity formula with superior healing properties resulting in a smooth and glossy surface with excellent chemical resistance.
Quick Facts: UMC-85™
Solids Content – 85% by weight
Dry Time, Tack Free – 4 to 6 hours
Dry Time, Foot Traffic – 10 to 18 hours
Dry Time, Heavy Traffic – 24 to 36 hours
Recoat Interval – 6 to 16 hours
Application Temperature
50° to 80° F
VOC Content – < 50 g/L
COVERAGE
Coverage rates will vary greatly depending on surface porosity and application method. Avoid thick build of UMC-85, this is a thin mil coating that will not cure clear if allowed to puddle.
Direct to Concrete: 250 – 350 sq ft per gallon
Top Coat: 300 – 400 sq ft per gallon
Over Broadcast System: 175 – 225 sq ft per gallon
TYPICAL USES of UMC-85™
The unique formula used in Industrial, Commercial, and Residential applications such as:
Fire station, Auto Service Centers
Residential Garages and Basements
Retail, Restaurants and Hospitality
Countertops (USDA Approved)
Top Coats Over May Other Products
PRODUCT ADVANTAGES of UMC-85™
UV Stable
Great Stain and Chemical Resistance
High Gloss Finish for Metallic or Stain Floor Systems
No Measuring or Mixing
MIXING INSTRUCTIONS
Stir product prior to use as separation may occur during storage.
APPLICATION INSTRUCTIONS
Dip and roll from a roller tray. Do not over-work the product.
RECOAT: Recoat time listed above is directly affected by the ambient surface temperature. Apply additional coatings as early in the recoat window as possible for the best results. Even within the recoat window it is recommended to abrade and clean the existing coat. If the recoat window has passed, it is critical to thoroughly abrade the surface with 80 to 120 grit sanding screens. Thoroughly clean the existing coating before abrading to remove potential contaminants.