Faster Setting 100% Solids Epoxy Clear - Tintable

PS-90 Polyaspartic

Long Pot Life 90% Solids Polyaspartic

 PS-90 is a long pot life 90% solids low odor polyaspartic floor coating system. Utilizing a special blend of low odor solvent components the pot life is extended while allowing for a quick return to service. PS-90 is clear and may also be field-tinted with fourteen solid standard colors and four safety colors utilizing the PS-TINT packs.

Quick Facts: PS-90 Polyaspartic

Solids Content – 90% by weight

Pot Life – 45 minutes

Dry Time, Tack Free – 3 to 5 hours

Dry Time, Foot Traffic – 4 to 8 hours

Dry Time, Heavy Traffic – 24 to 48 hours

Re-coat Window – 2 to 18 hours

Application Temperature: 
50° to 80° F

VOC Content – < 250 g/L (Mixed)

 Packaging:

2-Gallon Kits

10-Gallon Kits

COVERAGE  

Coverage rates will vary greatly depending on surface porosity and application method. Avoid thick build of PS-90, as this is a thin mil coating that will not cure clear if allowed to puddle.

Direct to Concrete: 200 – 350 sq ft per gallon
Top Coat: 300 – 400 sq ft per gallon
Over Broadcast Media: 150 – 225 sq ft per gallon

TYPICAL USES of PS-90 Polyaspartic:

Versatile Polyaspartic that can be used in Industrial, Commercial, and Residential applications such as:

Fire station, Auto Service Centers

Residential Garages and Basements

Manufacturing and Warehouse Floors

Retail, Restaurants and Hospitality

Breweries

PRODUCT ADVANTAGES PS-90 Polyaspartic

UV Stable

45 Minute Pot Life at 70° F

Low Odor and VOC Compliant

Part of the One-day Flake Floor System

Field Tintable with Pigment Packs

Fast Return to Service

MIXING INSTRUCTIONS 

If less than full kits will be mixed, each component should be mixed thoroughly with individual tools. Using the same tool to mix part A and Part B will cause contamination and ruin the material being saved for future use. PS-90 is to be mixed at a ratio of 1 parts A to 1 part B. In clean mixing containers pour the correct ratio in and mechanically mix for 3 minutes using a Jiffy-style mixer. DO NOT USE A STIR STICK! The amount of material mixed should only be what can be utilized within the listed pot life of the product.

APPLICATION INSTRUCTIONS 

Dip and roll mixed product from a roller tray. Do not over-work the product.

RECOAT: Recoat time listed above is directly affected by the ambient surface temperature. Apply additional coatings as early in the recoat window as possible for the best results. Even within the recoat window it is recommended to abrade and clean the existing coat. If the recoat window has passed, it is critical to thoroughly abrade the surface with 80 to 120 grit sanding screens. Thoroughly clean the existing coating before abrading to remove potential contaminants.